AAAAAAAADDDDDDDDEEEEEEEEMMMMMMMMCCCCCCCCOOOOOOOO OOOOOOOOppppppppttttttttiiiiiiiifffffffflllllllleeeeeeeexxxxxxxx VVVVVV
Optiflex Installation and Setup Guide 2-4 To wire Optiflex, refer to the Summary of Connections diagram at the rear of this guide and do the following
Section 2: Mounting and Wiring 2-5 NTSC Output Configuration Selects either one camera or guard tour (camera scanning) for default local viewing thr
Optiflex Installation and Setup Guide 2-6 Optiflex can be reset to its default settings by pressing and holding the top reset button for 10 secon
3-1 SECTION 3 Setting Up Optiflex Using Symphony ••••••••••••••••••••••••••••••••••••••••••••••••• In This Section ♦ How to Select Video from the S
Optiflex Installation and Setup Guide 3-2 How to Set Up Video Options on Symphony 1. Press the SECURITY button on the “Home” screen. The “Arming”
4-1 SECTION 4 Operational Status Indicators ••••••••••••••••••••••••••••••••••••••••••••••••• Camera Status LEDs Cameras 1 – 6 LEDs ON – Camera det
Optiflex Installation and Setup Guide 4-2 Optiflex Status LEDs Camera Status Off – All detected cameras are connected Flashing – At least one camera
5-1 SECTION 5 Specifications ••••••••••••••••••••••••••••••••••••••••••••••••• Specifications MECHANICAL Dimensions: Width 7 ½ inches Height 6 ½ in
Optiflex Installation and Setup Guide 5-2
6-1 SECTION 6 Summary of Connections ••••••••••••••••••••••••••••••••••••••••••••••••• optiflex-SOC-V3DIPSWITCH234561ON78COMPOSITEVIDEOOUT10 baseTET
Optiflex Installation and Setup Guide 6-2
NOTES
LIMITED WARRANTY Honeywell International Inc., acting through its Security & Custom Electronics business ("Seller") 165 Eileen Way, S
165 Eileen Way, Syosset, NY 11791 Copyright 2004 Honeywell International Inc. www.honeywell.com/secur
i Table of Contents ••••••••••••••••••••••••••••••••••••••••••••••••• Ssection 1: General Information ...
1-1 SECTION 1 General Information ••••••••••••••••••••••••••••••••••••••••••••••••• In This Section ♦ Introduction to Optiflex ♦ Optiflex Features
Optiflex Installation and Setup Guide 1-2 Optiflex Typical System Block Diagram A typical Optiflex System Block Diagram is shown in Figure 1. Optifle
2-1 SECTION 2 Mounting, Wiring, and Setup ••••••••••••••••••••••••••••••••••••••••••••••••• In This Section ♦ Setup Considerations ♦ Mounting Optif
Optiflex Installation and Setup Guide 2-2 • Voltage Trigger and Output Programming commands are interchangeable for turning on a camera. • “All
Section 2: Mounting and Wiring 2-3 Wiring and Setup of Optiflex Before wiring Optiflex, make sure power is turned off and review the important notes b
Comments to this Manuals