Honeywell NETAXS-123 User Manual download pdf (Page 22)

14 www.honeywell.com

Installing the NetAXS-123 Panels

Installation

6. Connect the Ethernet cable and the Tamper wire, as shown below.

7. Set DIP switch settings for the panel address, communication termination and biasing. See DIP

Switch Settings, page 36.

8. Check all wiring at this time.

Caution: Improper wiring can cause damage to the NetAXS-123 at power up and result in a loss

of warranty.

9. Apply power to the panel.

10.Check for the Run LED for a successful power-up. If the LED is blinking green, the panel is

powered up successfully.

11.Close the cover.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 75 76

No comments

Honeywell NETAXS-123 User Manual Page 22