Honeywell ISM BAND XYR 5000 LINE User Manual download pdf (Page 22)

(recommended in section 3.2.1) the value of the resistor should be a 120 Ohm ¼ watt

resistor.

To terminate a Base Radio, place one end of the resistor in the open terminal block’s B

slot and place the other end of the resistor in the open terminal block’s A slot. Doing so

will place the resistor across the A and B wires, as needed. An example of this is shown

in Figure 3-10.

Figure 3-10 Example of Correct Termination Resistor Setup

3.2.8 Grounding the Base Radio

ts on your Base Radio, the Base Radio housing must

Possible grounded objects include:

• The building’s metal frame-work

• Any electrical conduit

• A suitable grounding or lightning rod

3.2.9 High Gain Antenna

ilable for the Base Radio. This antenna generally doubles the

In order to assure safety requiremen

be grounded. We have provided a grounding screw located on the left side of the Base

Radio housing. To ground the Base Radio simply place a wire from the grounding screw

to a grounded object.

A high-gain antenna is ava

signal range of the Base Radio, but requires an installation in a general-purpose area.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 48 49

No comments

Honeywell ISM BAND XYR 5000 LINE User Manual Page 22