Honeywell HFD110 User Manual download pdf (Page 6)

•

To replace the permanent, washable pre-filters with the

Odor-Lock

™

pre-filters, remove the standard washable

pre-filter assembly by pushing on the top tab (Fig.16).

•

The pre-filter assembly has two pre-filters that will need

to be popped out of the pre-filter frame. Hold the frame

steady from the side while pushing in the center of each

pre-filter from the back side of the frame (Fig.17). This

will separate the pre-filter from the frame and you can

then pull it completely away from the frame (it will snap

out) (Fig.18). Save the permanent washable pre-filters

as you may choose to use them in the future.*

•

To insert the Odor-Lock

™

pre-filters into the pre-filter

frame, line the tabs on the pre-filter up with the frame

notches and snap into place (Fig.19).

•

Install the Odor-Lock

™

filter assembly by inserting the

lower tab of the pre-filter frame into the filter assembly

until you hear a “click” (Fig. 20).

•

Align the complete filter assembly with the opening in

the unit and insert back into the unit (Fig. 21).

NOTE: The Odor-Lock

™

filters are not washable.

CLEANING THE WASHABLE PRE-FILTER (ALL MODELS)

To remove the pre-filter:

Press the top tab to release the pre-filter from the filter

assembly (Fig. 14).

To clean the pre-filter:

The particle pre-filter helps pick-up large airborne particles

that enter the filter. The pre-filter can be removed and rinsed

by hand under warm water (Fig. 15). Let the pre-filter dry

completely before inserting it back into the unit.

Some models are shipped with bonus odor control pre-filters that are not washable. After the pre-filters

have lost their odor reducing capability over time (approximately 3 months), you can order replacement

Odor-Lock

™

pre-filters by calling the Kaz USA, Inc. Consumer Relations Department at 1-800-477-0457.

INSTALLING THE ODOR-LOCK

™

PRE-FILTER(S) (HFD-014 ONLY)

REMOVING / CLEANING THE IFD

™

MICRO-FILTER FOR ALL MODELS FILTER (CONTINUED)

Fig. 14

Fig. 16

Fig. 15

Fig. 17

Fig. 18 Fig. 19

Fig. 20 Fig. 21

• Note that the filter may still be discolored even after washing.

This is acceptable and will not affect performance.

• Allow the ifD

™

Micro-filter to dry for a few hours or overnight.

• When the ifD

™

Micro-filter is completely dry, place back into the air purifier.

Make sure you insert the filter according to the directional arrows on the filter.

CAUTION:

• Never place a wet ifD

™

Micro-filter in your air purifier.

• Do not use any solvents, strong cleaning agents or flammable liquids to clean the ifD

™

Micro-filter.

1 2 3 4 5 6 7 8 9 10 11 ... 32 33

Comments to this Manuals

No comments

Honeywell HFD110 User Manual Page 6

Comments to this Manuals

Related products and manuals for Air purifiers Honeywell HFD110