Honeywell MS9590 VoyagerGS User's Guide download pdf (Page 22)

INDICATORS

Audible

During operation, the scanner provides audible feedback that indicates the status

of the scanner and latest scan. Eight settings are available for the tone of the

beep (normal, 6 alternate tones and no tone). To change the beeper tone, refer

to the MetroSelect

Single-Line Configuration Guide or MetroSet2’s help files.

One Beep

When the scanner first receives power, the blue LED will turn on, the white

LED will flash, and the scanner will beep once. The scanner is ready to scan.

When the scanner successfully reads a bar code, the white LED will flash and

the scanner will beep once.

Three Beeps

During Operation

When entering the configuration mode, the white LED will flash while the

scanner simultaneously beeps three times.

When exiting the configuration mode, the scanner will beep three times and

the white LED will stop blinking.

Three beeps can also indicate a communication timeout during normal

scanning mode if the scanner is configured to give this indication.

During Start-up

This is a failure indicator. Refer to “Failure Modes” on page 20.

Three Beeps

When using the single-code-configuration method, the scanner will sound a

3-combination tone (a single beep then a short pause followed by, a high tone,

and a low tone). This beep sequence signals that the single configuration bar

code has successfully configured the scanner.

Razzberry Tone

This tone indicates a type of failure. Refer to “Failure Modes" on page 20.

When in configuration mode, a short razzberry tone will sound if an invalid bar

code is scanned.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 46 47

No comments

Honeywell MS9590 VoyagerGS User's Guide Page 22