Honeywell EC-P2 User Manual download pdf (Page 8)

Honeywell EC-P2 Instruction and Installation Manual

System Speciﬁcations

Primary Power:

Alkaline D cell battery, 75 hours operation.

Note: An audible alarm single beep every 60 seconds

indicates that either the Alkaline D cell battery is low or

the internal rechargeable NiCad battery is low.

Standby Power:

Internal rechargeable NiCad battery, 6 hours

operation.

Note: An audible alarm single beep every 60 seconds

indicates that either the Alkaline C cell battery is low or

the internal rechargeable NiCad battery is low.

Charger:

120 VAC plug-in charger for internal standby battery

Display:

Backlit LCD

Pump:

Miniature internal diaphragm type, flowrate 0.5

SCFH

Alarms:

Two concentration alarms, zero drift caution, Low ﬂow

and Low battery alarms. Alarms displayed on LCD and

indicated by audible beeper.

Standard Accessories:

Storage case, 10” extension wand, battery charger,

ﬁlter material, datalogging software, RS-232 output

cable (DB9 connector)

Optional Accessories:

Analog output cable. Sensor Keeper for storage of

additional SMART-CELLs

Sensor Type:

Target gas selective electrochemical SMART-CELL

Accuracy:

Sensor dependant but generally ± 5% of reading

Repeatability:

± 1% full scale

Operating Ambient Temperature

Range:

0° to +120° F

Storage Temperature:

Recommend storing on the charger in an air

conditioned ofﬁce

Weight:

3 lbs. (shipping weight), 1.8 lbs. (detector only)

Dimensions:

Approx 3.5” x 5” x 8.5”

Outputs:

RS-232 output of stored gas values.

Analog output 0 to 1.0 VDC (requires optional

analog output cable)

Memory:

12,000 data points, storage interval between points

programmable at 1, 5, 10, or 15 minutes. Typical

capacity: 8 days at 1 minute storage interval

2.1 Operating the Sensor

The Honeywell EC-P2 is shipped ready for use. To power up the instrument, push

the PWR button. The power up sequence displays ﬁrst the self check, the sensor

full scale value, the downscale caution level, warning concentration setpoint, alarm

concentration setpoint, output ranges, software version, then the normal operating

screen.

The unit will then display the instantaneous gas concentration and is ready for

use.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comments to this Manuals

No comments

Honeywell EC-P2 User Manual Page 8

Comments to this Manuals

Related products and manuals for Oxygen Equipment Honeywell EC-P2