Honeywell PRESTIGE THX9421 User Manual Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
THX9321/9421 Prestige
®
IAQ and RF EIM
5
69-249003
MCR32941
CONNECT
CONNECTED
S2
S2
S1
S1
Link thermostat to the wireless network
(ifusedwithanEIMorTrueZONEWirelessAdapter)
4
Next,linkallcomponentsandRedLINK
accessoriestothewirelessnetwork.
Initial powerup configuration
Whenthethermostatisfirstactivated,itwillleadyouthroughthesteps
necessarytodefineandsetupyoursystem.Thestepswillchangedependingon
thetypeofsystemandthermostatyou'reinstalling.
Setup options for THX9321
If non-zoned system:
• Setupforthermostatonly
• SetupforusewithEIM
If zoned system:
• SetupforEIMwiredtozonepanel
• Setupforthermostatwiredtozonepanel
• SetupforRedLINKwirelessconnectiontozonepanel
(using THM4000 TrueZONE Wireless Adapter)
Setup options for THX9421
If non-zoned system:
• SetupforEIMconnection
If zoned system:
• SetupforEIMwiredtozonepanel
• SetupforRedLINKwirelessconnectiontozonepanel
(using THM4000 TrueZONE Wireless Adapter)
While the EIM light is flashing, press NEXT to link
the thermostat with the EIM. After a brief delay,
the screen will display "Device Connected."
Press and release the CONNECT button at the EIM or Wireless
Adapter, and make sure the "Connected" light is flashing green.
If the "Connected" light does not flash, make sure no other
RedLINK devices are in Wireless Setup mode, then try again.
Link thermostat to EIM or TrueZONE
®
Wireless Adapter
Usethestep-by-stepthermostatmenustodefineyoursystemtype(above).
WhenyoureachtheWirelessSetupscreen,followthestepsbelow:
At any screen you can press HELP for more information,
or press BACK to change earlier options.
If the "Connected" light does not flash on the Wireless
Adapter, consult the TrueZONE manual for help.
"Connected" status light
• Green flashing: In Wireless Setup mode.
• Green steady: System is working normally.
• Red: Wireless device(s) not communicating. Check EIM and RedLINK devices.
69-2490_B.indd 5 7/13/2011 1:41:50 PM
Page view 4
1 2 3 4 5 6 7 8 9 10 ... 27 28

Comments to this Manuals

No comments