Honeywell XG1000 User Manual download pdf (Page 3)

DEVICE OVERVIEW PAGE

DISCOVERY

BUTTON

5. Log into your remote account via a PC browser. Click on the Account Settings tab on the

interface and then select the Discovery sub-tab, to access the Discovery page.

NOTE: If your XG1000 Controller is not registered to your account you

must register it prior to proceeding.

On the Discovery page, click on the ‘START DISCOVERY’ button

to start the Bridge registration process. When the page heading

indicates that discovery is in process, press the ‘DISCOVERY’

button on the lower left corner of the Honeywell Bridge device

as shown.

When the Discovery process has finished for the Honeywell Bridge, it will appear on the list

of your devices on the Discovery page, and the LED on the Honeywell Bridge should turn GREEN.

At this point you may press the ‘STOP DISCOVERY’ button to stop the Discovery process.

After the system has registered the Honeywell Bridge device, go to the Device Overview page and

verify that the Honeywell Bridge device was properly discovered.

DEVICE DISCOVERY PAGE

HONEYWELL ALARM PANEL DISCOVERED

DEVICE DISCOVERY IN PROGRESS

COMPLETING THE INSTALLATION ///

1. Access your remote account via a PC browser and log in using your account UserID

and Password.

2. Click on the Device Overview tab to access the Device List for the system.

Once you are at the Device List, click on the Settings icon for the HoneywellAlarmPanel

to the right of the Device List.

3. Send a test command through the Virtual Keypad to disarm the system and the status of

the panel will appear.

1 2 3 4

No comments

Honeywell XG1000 User Manual Page 3