Honeywell DOLPHIN 99EX User Manual Page 139

  • Download
  • Add to my manuals
  • Print
  • Page
    / 190
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 138
12 - 9
Serial Connector
The following diagram displays the pin diagram of the serial connector of the base.
Note: The signal names are referenced to the terminal. The terminal is a DCE RS232 device. Refer to section,
RS232 Communications Cables and RS232 Pin Configuration for more details. The base is at a right-angle
to the printed circuit board (PCB). The ninth pin has a ring indicator (RI).
Mounting the HomeBase
Set the base on a dry, stable surface, such as a desktop or workbench near an electrical outlet. Be sure
to provide enough workspace with good lighting for the user to view and operate the Dolphin terminal
while it is in the base.
When choosing a mounting location, bear in mind that the location must allow users' easy access to the
Auxiliary Battery Well and the back panel of the HomeBase where the serial port, USB port, and the
power jack are located.
Desk Mounting
The DIN rail slot (7.5 X 35 mm) may be mounted
on the bottom to allow for secure desk attachment
of the unit if desired.
Hardware Required
3/16 in. dia x 5/8 in. long pan head screw
1/2 in. OD x 7/32 in. ID x 3/64 in. thick
3/16 in. dia nut
Installing the DIN Rail
1. Slide the DIN rail into the slot along the bot-
tom panel of the base.
2. Then, using the appropriate nuts and bolts, secure the DIN rail to the desk or flat surface.
Pin Description
1 Internal Jumper to Pin 6
2TXD
3RXD
4 No Connect
5GND
6DTR
7CTS
8RTS
9RI
Serial and USB port
location (not in view)
DIN Rail (7.5 X 35 mm)
Page view 138
1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 189 190

Comments to this Manuals

No comments