Honeywell Scanner 1900 User Manual download pdf (Page 112)

4 - 18

Low Priority Symbology

To specify the low priority symbology, scan the Low Priority Symbology bar

code below. On the Symbology Chart on page A-1, find the symbology you

want to set as low priority. Locate the Hex value for that symbology and

scan the 2 digit hex value from the Programming Chart (inside back cover).

If you want to set additional low priority symbologies, scan FF, then scan

the 2 digit hex value from the Programming Chart for the next symbology.

You can program up to 5 low priority symbologies. Scan Save to save your

selection.

Default = None

Preferred Symbology Time-out

Once you have enabled Preferred Symbology and entered the high and low

priority symbologies, you must set the time-out period. This is the period of

time the scanner will search for a high priority bar code after a low priority

bar code has been encountered. Scan the bar code below, then set the

delay (from 1-3,000 milliseconds) by scanning digits from the inside back

cover, then scanning Save.

Default = 500 ms.

Preferred Symbology Default

Scan the bar code below to set all Preferred Symbology entries to their

default values.

Low Priority Symbology

Preferred Symbology Time-out

Preferred Symbology Default

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 297 298

No comments

Honeywell Scanner 1900 User Manual Page 112