Honeywell Scanner 1900 User Manual download pdf (Page 31)

1 - 9

Setting Custom Defaults

You have the ability to create a set of menu commands as your own, custom

defaults. To do so, scan the Set Custom Defaults bar code below before each

menu command or sequence you want saved. If your command requires scan-

ning numeric codes from the back cover, then a Save code, that entire

sequence will be saved to your custom defaults. Scan the Set Custom

Defaults code again before the next command you want saved to your custom

defaults.

When you have entered all the commands you want to save for your custom

defaults, scan the Save Custom Defaults bar code.

Note: If using a cordless system, scanning the Save Defaults bar code also

causes both the scanner and the base

or Access Point to perform a reset

and become unlinked. The scanner must be placed in its base to re-

establish the link before any setup codes are entered. If using an Access

Point, the linking bar code must be scanned. See Cordless System

Operation beginning on page 3-1 for additional information.

You may have a series of custom settings and want to correct a single setting.

To do so, just scan the new setting to overwrite the old one. For example, if you

had previously saved the setting for Beeper Volume at Low to your custom

defaults, and decide you want the beeper volume set to High, just scan the Set

Custom Defaults bar code, then scan the Beeper Volume High menu code,

and then Save Custom Defaults. The rest of the custom defaults will remain,

but the beeper volume settiing will be updated.

Resetting the Custom Defaults

If you want the custom default settings restored to your scanner, scan the Acti-

vate Custom Defaults bar code below. This is the recommended default bar

code for most users. It resets the scanner to the custom default settings. If

Save Custom Defaults

Set Custom Defaults

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 297 298

No comments

Honeywell Scanner 1900 User Manual Page 31