Honeywell SC1000 User Manual download pdf (Page 15)

SC Series Instruction Manual page 15

Getting Started Quickly2

Chapter 2

Getting Started Quickly

2.1 Locate Required Parts and Information

The following items are required to set up an SC Series instrument with your

transducer:

• SC Series instrument

• Transducers that are to be connected to the instrument

• For each transducer to be connected to the instrument, a connecting cable.

This cable will have a 12-pin, green, plastic connector on one end and the

transducer’s mating connector on the other end. Usually, this cable is ordered

along with the instrument and transducer.

If the connecting cable was not ordered with the instrument, you may need to

make this cable.

• The transducer’s Calibration Record or Certificate of Calibration.

• The Customer Information Sheet that shipped with your instrument. This

sheet describes which cards are installed in each channel.

• Power cord for the instrument.

2.2 Connect the Transducer to the Correct Channel of the Instrument

For each transducer, attach its connecting cable to the transducer, and then to the

correct 12-pin channel-connector on the instrument.

The Customer Information Sheet indicates which serial numbered transducer is to

be connected to each channel of the instrument.

If the instrument and transducer(s) were not purchased with a connecting cable,

you may need to make this cable. For the transducer’s pin connections, see that

transducer’s calibration record. For the pin connections for that channel of the

instrument, see the appropriate chapter in this manual. For example, if you wish

to wire to a Strain-Gage Input Channel see the chapter “Strain-Gage Input Chan-

nel” on page 59.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 173 174

No comments

Honeywell SC1000 User Manual Page 15