Honeywell SC1000 User Manual download pdf (Page 28)

page 28 008-0608-00

Figure 4-2: Panel Cutout Drawing for SC1000 & SC2000 (not to scale)

Step 1: In the panel or rack, cut a hole as shown above. The panel may be up to 1/4”

in thickness.

Step 2: Use an 0.062" Allen wrench to remove two set screws that hold the Panel-

Mounting Jacks to the case. To do this, insert the wrench into the side slots at

the rear. Remove the screws completely.

Step 3: Remove the Panel-Mounting Jacks by sliding them toward the rear. If the jacks

don't slide easily, tap them gently.

Step 4: Put the instrument through the hole in the panel.

Step 5: Reinsert the Panel-Mounting Jacks into the slide slots. Slide them as far

toward the panel as possible.

Step 6: Reinsert the setscrews and tighten them. This will force the Panel-Mounting

Jacks toward the rear side of the panel, drawing the instrument tightly into

place.

4.3.5 Rack Mounting

A Rack Mounting Kit (order code AA934) is available for mounting a single SC1000 or

SC2000 into a 19”, 2U rack. It includes the Panel-Mounting Jacks described above as

well as the 19” rack panel.

4.3.6 Bench Mounting

If bench mounting the instrument, you may want the optional carrying handle/bench

stand (order code AA926).

4.3.7 Case Removal

WARNING

Disconnect the power cord and all cables from the instrument before attempt-

ing to remove the case.

Failure to comply with these instructions could result in death or serious

injury.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 173 174

No comments

Honeywell SC1000 User Manual Page 28